Esteem GL Wagon L4-1.8L (1999)
5.
Install the sleeve assembly on the valve shalt, aligning the pin on the sleeve assembly with the groove in the valve shaft, then install the new
retaining ring.
Assembly of the Valve Housing
6.
Multi-purpose Wheel Bearing Grease # 2 grade to the following areas.
^
External part of the new stub oil seal
^
Internal surface of the valve housing
^
Taper side of the special tool "Pinion bearing remover & installer"
SERVICE MATERIAL:
Multi-purpose Wheel Bearing Grease # 2 grade
SPECIAL TOOL:
09943-86010
Pinion bearing remover
& installer
7.
Place a new stub oil seal and the ball bearing on the special tool Pinion bearing remover & installer, position them in the valve housing by hand.