Esteem GL Wagon L4-1.8L (1999)
5. Remove brake back plate from knuckle.
6. Loosen control rod outer bolts, trailing rod rear bolt and strut bracket nuts.
7. Disconnect control rods (No.1 and No.2) from knuckle.
8. Disconnect trailing rod from knuckle.
9. Remove knuckle from strut.
INSTALLATION
1. Install rear knuckle to strut, and connect control rods and trailing rod to knuckle. At this point, temporarily tighten them by hand.
2. Tighten strut bracket bolts and nuts to specified torque.
Tightening Torque (a): 90 Nm (9.0 kg-m, 65.0 ft. lbs.)
