Forenza L4-2.0L (2004)
Front Bumper Reinforcement: Service and Repair
Front Bumper Impact Bar Removal and Installation
Front Bumper Impact Bar Removal And Installation
Removal
1. Disconnect the electrical connector.
2. Remove the front bumper fascia.
3. Remove the front bumper energy absorber.
4. Remove the bolts and the front bumper impact bar.
Installation
CAUTION: Dissimilar metals in direct contact with each other may corrode rapidly. Make sure to use the correct fasteners to prevent
premature corrosion.
1. Install the front impact bar with the bolts.
Tighten:
Tighten the front impact bar bolts to 39 Nm (29 ft. lbs.).
2. Install the front bumper energy absorber.
3. Install the front bumper fascia.
4. Connect the electrical connector.