Forenza L4-2.0L (2004)
4. Install the rubber boot on the booster.
5. Install the booster and the mounting nuts to the dash panel.
Tighten: Tighten the booster-to-dash panel nuts to 22 Nm (16 ft. lbs.).
6. Attach the shaft and the rubber O-ring.
7. Connect the master cylinder to the booster.
8. Connect the brake line fittings to the hydraulic modulator, if applicable.
Tighten: Tighten the brake line fittings to 16 Nm (12 ft. lbs.).
Tighten: Tighten the master cylinder attaching nuts to 24 Nm (18 ft. lbs.).
9. Install the new vacuum hose to the booster.
10. Install the hose clamps on the vacuum hose, and snap the vacuum hose in the revolving clip.
11. Install the pushrod pin to the brake pedal bracket assembly and connect the clip and the spring.
