Forenza L4-2.0L (2004)
drive plate remover/installer J-33013-B should be backed off sufficiently to allow the center bolt to be threaded onto the end of the compressor
shaft.
5. Install the hub and drive plate remover/installer J-33013-B and the bearing onto the clutch drive plate. Thread the center bolt onto the compressor
shaft.
6. Hold the center bolt with a wrench. Tighten the hex portion of the hub and drive plate remover/installer J-33013-B body to press the hub onto the
shaft. Tighten the body several turns.
7. Remove the hub and drive plate remover/installer J-33013-B and check to see that the clutch hub key is still in place in the keyway before
installing the clutch drive plate and the hub assembly to its final position. The air gap between frictional surfaces of the clutch drive plate and the
clutch pulley rotor should be 0.38 - 0.64 mm (0.015 - 0.025 in.).
8. Remove the hub and drive plate remover/installer J-33013-B. Check for proper positioning of the clutch hub key. It should be even or slightly
above the clutch hub.
9. Install the shaft nut. Hold the clutch drive plate and the hub assembly with the clutch hub holding tool J-33027. Use the shaft nut socket J-33022
and tighten the nut against the compressor shaft shoulder.
Tighten: Tighten the clutch plate and hub assembly retaining nut to 17 Nm (13 ft. lbs.).
10. Spin the pulley rotor by hand to verify that the pulley is not rubbing the clutch drive plate.
11. Remove the compressor from the bench vise and remove the J-34992 compressor holding fixture from the compressor.
12. Install the compressor.