Forenza L4-2.0L (2004)
9. Remove the liquid pipe block-to-expansion valve retaining nut at the fire wall.
10. Remove the headlamp housing at the right-hand side.
11. Remove the liquid pipe block-to-receiver dryer retaining nut.
12. Remove the bolts which secure the support clamps that hold the liquid pipe to the vehicle.
13. Remove the liquid pipe from the vehicle.
14. Cap the opening at the receiver-dryer to prevent contamination.
Installation
1. Position the liquid pipe into the vehicle.
2. Install the liquid pipe support clamp bolts.
Tighten: Tighten the liquid pipe support clamp bolts to 4 Nm (35 in. lbs.).
