Forenza L4-2.0L (2004)
Control Module: Procedures
TCM Initialization Procedure
When one or more operations such as shown below are performed, all learned contents which are stored in TCM memory should be erased after the
operations.
^
When A/T H/W is replaced in a vehicle.
^
When a used TCU is installed in other vehicle.
^
When a vehicle condition is unstable (engine RPM flare, TPS toggling and so on; at this kind of unstable conditions, mis-adaptation might be
done).
1. Connect the scan tool with a DLC connector in a vehicle.
2. Turn ignition switch ON.
3. Turn the power on for the scan tool.
4. Follow the "TCM LEARNED INITIALIZE" procedure on the scan tool menu.
NOTE: Before pushing "Yes" Button for TCM initialization on the scan tool screen, make sure that the condition is as follows:
Condition:
1. Engine idle.
2. Select lever set "P" range.