Grand Vitara 2WD L4-2.4L (2009)
Condenser HVAC: Service and Repair
A/C Condenser Assembly Removal and Installation
CAUTION: Do not damage condenser fins. If condenser fin is bent, straighten it by using flat head screwdriver or pair of pliers.
Removal
1. Disconnect negative (-) cable at battery.
2. Recover refrigerant from A/C system referring to Operation Procedure for Charging A/C with Refrigerant.
NOTE: The amount of removed compressor oil must be measured for replenishing compressor oil.
3. Remove front bumper assembly referring to Front Bumper Components.
4. Remove front bumper upper member.
5. Disconnect compressor discharge hose (1) and liquid pipe (2) from condenser assembly (4).
CAUTION: As soon as above hose and pipe are disconnected, cap opened fittings so that moisture and dust do not enter condenser.
6. Remove condenser assembly mounting bolts (3), and then remove condenser assembly.
NOTE: Be careful not to damage fins of condenser and radiator.
Installation
Reverse removal sequence to install condenser, noting the following point.
-
Replenish specified amount of compressor oil to compressor suction side referring to Precautions on Replenishing Compressor Oil.
-
Evacuate and charge the A/C system referring to "Evacuation" and "Charge" in Operation Procedure for Charging A/C with Refrigerant.