Grand Vitara 2WD V6-2.7L (2006)
3. Connect harness clamp to bracket.
4. Install ECM, referring to Engine Control Module (ECM) Removal and Installation.
5. Connect negative (-) cable at battery.
6. Bleed air from brake system, referring to Air Bleeding of Brake System.
7. Check each installed part for fluid leakage and perform Hydraulic Unit Operation Check.
NOTE:
For new ABS (ESP) hydraulic unit / control module assembly, if Hydraulic Unit Operation Check has not been performed, ABS warning lamp
may flash when ignition switch is turned ON position.
Accordingly perform Hydraulic Unit Operation Check to stop flashing of ABS warning lamp.