Grand Vitara 2WD V6-2.7L (2006)
5) Install cylinder head covers (1) to cylinder heads.
6) Using new seal washers (3), tighten nuts (2) following sequence ("1" - "4") as indicated in figure. Tighten a little at a time and evenly among nuts
and repeat tightening sequence 2 or 3 times before they are tightened to specified torque.
Tightening torque
Cylinder head cover nut a: 10.5 Nm (1.1 kg-m, 7.5 ft. lbs.)
7) Install ignition coils and connect ignition coil couplers.
8) Clamp engine harness (2) to cylinder head cover.
