Grand Vitara 2WD V6-2.7L (2006)
9. Re-check the belt tension to ensure that it is adjusted properly. If the measured value is not within the specified value, repeat the applicable
adjustment step.
10. Using the 12mm socket and Torque wrench, tighten the tensioner bolt and adjusting bolt to the specified torque spec listed in the table.
11. Start the engine in order to stabilize the drive belt tension and stop it after it has run for 2-3 seconds, then measure the deflection or tension again. If
the measured value is not within the specified value, repeat the applicable adjustment step. If the measurement is acceptable proceed to the next
step.
12. The repair is now complete. Please affix the "SB" campaign label to the upper radiator support in a place where it can be easily seen and identified.
Disclaimer
