Grand Vitara 2WD V6-2.7L (2006)
7. Set the Sonic Tension Meter to reflect the "Frequency Filter Setting" values from the table . Insert the 10mm Hex tool in the hexagonal hole (2) on
the pulley and turn it counterclockwise to increase, clockwise to decrease the tension on the belt to achieve the specified value indicated in the table
below, and then tighten the adjusting bolt and pulley bolt temporarily. Proceed to step 10.
Grand Vitara (JB627) Torque Method
8. Using the 10mm Hex socket and torque wrench from the "tool list", insert the 10mm Hex tool in the hexagonal hole on the pulley and turn it
counterclockwise, increasing the tension until the prescribed amount of torque is being applied to the tensioner pulley as indicated in the table, and
then tighten the adjusting bolt and pulley bolt temporarily. Proceed to step 10.
