Grand Vitara 2WD V6-2.7L (2006)
Enabling Air Bag System
Enabling Air Bag System
1. Confirm that battery negative (-) cable is disconnected.
2. Turn ignition switch to "LOCK" position and remove key.
3. Connect yellow connector (1) of contact coil and combination switch assembly by pushing connector till click is heard from it.
4. Connect yellow connector (1) of passenger air bag (inflator) module by pushing connector till click is heard from it.
5. Install glove box.
6. If equipped with side-air bag (inflator) module, connect yellow connector (1) of side-air bag (inflator) module by pushing connector till click is
heard from it.
7. If equipped with side curtain-air bag (inflator) module, connect black connector (1) securely as shown in the figure.
a. Connect connector.
b. Lock connector with lock button (2).
8. Install "A/B" fuse to fuse box.
9. Connect negative (-) cable at battery.
10. Turn ignition switch to ON position and verify that "AIR BAG" warning lamp flashes 6 times and then turns OFF. If it does not operate as
described, perform Air Bag Diagnostic System Check:Advanced Air Bag. See: Restraint Systems/Air Bag Systems/Testing and
Inspection/Component Tests and General Diagnostics/Diagnostic Strategies/With Advanced Air Bag/Air Bag Diagnostic System Check
