Grand Vitara 2WD V6-2.7L (2006)
Air Bag Control Module: Service and Repair
With Advanced Air Bag
OCM With Sensor MAT Removal and Installation
OCM with Sensor Mat Removal and Installation
WARNING: As Occupant Classification Module (OCM) consists of precision parts, be careful not to expose it to excessive shock. Be sure to
read "Precautions on Service and Diagnosis of Air Bag System: H27 Engine Model (Advanced Air Bag)" before starting to work and observe
every precaution during work. Neglecting them may result in personal injury or inactivation of the air bag system when necessary.
CAUTION: Do not remove OCM with sensor mat from front passenger seat cushion assembly. When replacing OCM with sensor mat, be sure to
replace front passenger seat cushion assembly.
SDM Removal and Installation
SDM Removal and Installation
WARNING: During service procedures, be very careful when handling a Sensing and Diagnostic Module (SDM).
Be sure to read Precautions on Service and Diagnosis of Air Bag System:Advanced Air Bag before starting to work and observe every
precaution during work. Neglecting them may result in personal injury or inactivation of the air bag system when necessary.
Removal
1. Disconnect negative (-) cable at battery.
2. Disable air bag system referring to Disabling Air Bag System:Advanced Air Bag.
3. Remove console rear panel referring to Console Box Components.
4. Disconnect SDM connector (1) from SDM (2).
5. Remove SDM (1) from vehicle.
Installation
Reference: SDM Inspection:Advanced Air Bag
1. Check that none of the following faulty conditions exists.
-
Bend, scratch, deformity in vehicle body where SDM is mounted.
-
Foreign matter or rust on mating surface of vehicle body where SDM is mounted.
2. Install SDM (2) to vehicle.
CAUTION: Ensure that arrow on the SDM is pointing toward the front of the vehicle.