Grand Vitara 2WD V6-2.7L (2006)
7. Connect disconnected jumper wire end to terminal "2", then check that voltage between terminal "4" and terminal "2" changes as shown. If check
result is not satisfied, replace switch.
Washer Linked Circuit
1. Make sure that front wiper switch is at "OFF" position.
2. Connect battery positive (+) terminal to terminal "5" and its negative (-) terminal to terminal "2".
3. Connect voltmeter positive lead to terminal "4" and its negative lead to terminal "2".
4. When front washer switch is ON, check that voltage changes as shown in figure. If check result is not satisfied, replace switch.