Grand Vitara 2WD V6-2.7L (2006)
Front Steering Knuckle: Service and Repair
Steering Knuckle Removal and Installation
Steering Knuckle Removal and Installation
Removal
1. Hoist vehicle and remove wheel.
2. Remove Front wheel hub assembly.
3. Disconnect tie-rod end (1) from steering knuckle (2) with puller (3).
4. Remove front wheel speed sensor (1) from knuckle.
5. Loosen ball joint nut (2).
6. Remove strut bracket bolts (2) and nuts (1).
7. Disconnect ball joint from steering knuckle (2) with puller and then remove steering knuckle (2).