Grand Vitara 2WD V6-2.7L (2006)
13.
Re-install the middle shaft assembly to the vehicle. Connect and tighten the bolts on the flange and the nut and bolt of the upper U-joint on the
interior side of the dash panel. Flange bolts and upper U-joint nut torque 23 Nm (17.0 lb-ft). Re-install the under cover.
14.
In the engine compartment align the middle shaft mark with the lower shaft U-joint. Slide the shaft into the U-joint.
NOTE:
It may be required to insert and turn the ignition key to run to unlock the steering wheel.
CAUTION:
Do not allow the steering wheel to turn more than one inch from center; damage to Airbag contact coil cable assembly can occur.