Grand Vitara 2WD V6-2.7L (2006)
5. Install suspension frame.
WARNING: When installing suspension frame, be sure to apply some supporting equipment under it at well-balanced position as shown
in the figure section so as to prevent from its drop.
CAUTION: Lug (2) in suspension frame (1) must be mated to the corresponding hole in body. And also engine front body side mounting bolts
(3) must be mated to the F: Forward corresponding holes (4) in suspension frame.
6. Tighten suspension frame mounting bolts (1) and engine front body side mounting nuts (2) to specified torque.
CAUTION: If reuse suspension frame mounting bolt, apply engine oil to thread, bearing and trunk surface.
Tightening torque
Suspension frame mounting bolt a: 135 Nm (13.5 kg-m, 98.0 ft. lbs.)
Engine front body side mounting nut b: 55 Nm (5.5 kg-m, 40.0 ft. lbs.)
