Grand Vitara 2WD V6-2.7L (2006)
5. Install control rod to rear suspension knuckle tighten control rod outer bolt (1) temporarily by hand.
CAUTION: If reuse control rod outer bolt, apply engine oil to thread, bearing and trunk surface.
6. Remove floor jack from lower arm.
7. Install rear brake hose bracket (1) and then tighten rear brake hose bracket bolt (2) to specified torque.
8. Install rear wheel sensor (1) and then tighten wheel sensor bolt (2) to specified torque.
Tightening torque
Rear wheel sensor bolt a: 11 Nm (1.1 kg-m, 8.0 ft. lbs.)