Grand Vitara 2WD V6-2.7L (2006)
Transmission Speed Sensor: Service and Repair
Input Shaft Speed Sensor Removal and Installation
Input Shaft Speed Sensor Removal and Installation
Removal
1. Disconnect negative cable at battery.
2. Hoist vehicle.
3. Disconnect input shaft speed sensor connector.
4. Remove input shaft speed sensor (1) from transmission.
Installation
1. Check that sensor is free from any metal particles and damage.
2. Apply A/T fluid to new O-ring and then install input shaft speed sensor (1) to transmission. Tighten sensor bolt to specified torque.
3. Connect input shaft speed sensor connector.
4. Lower hoist.
5. Connect negative cable at battery.
