Grand Vitara 2WD V6-2.7L (2006)
Shift Solenoid: Testing and Inspection
Solenoid Valves (Shift Solenoid-A, Shift Solenoid-B, Shift Solenoid-E, TCC Solenoid, Pressure Control Solenoid-A, Pressure Control
Solenoid-B, and Pressure Control Solenoid-C) Inspection
Solenoid Valves (Shift Solenoid-A, Shift Solenoid-B and Shift Solenoid-E)
Resistance check
CAUTION: Be very careful as dust etc. does not enter when solenoid valves are inspected.
Measure resistance between terminal (2) and solenoid valve body. If resistance is out of specification, replace solenoid valve.
Operation Check
^
With solenoid connected to battery (2) as shown in the figure, check that solenoid valve is actuated with click sound.
^
With shift solenoid valve (1) connected to battery (2), confirm that shift solenoid valve is open by blowing air (50 - 200 kPa, 0.5 - 2.0 kg/cm2, 7 -
28.5 psi) into solenoid valve as shown in the figure.
^
With shift solenoid valve (1) not connected to battery (2), confirm that shift solenoid valve is closed by blowing air (50 - 200 kPa, 0.5 - 2.0
kg/cm2, 7 - 28.5 psi) into solenoid valve as shown in the figure.
CAUTION: Do not insert air gun against strainer installed on inlet of solenoid valve too deeply, when blowing air into solenoid valve. If not, the
strainer will be damaged.
