Grand Vitara 2WD V6-2.7L (2006)
Windshield Washer Switch: Testing and Inspection
Windshield Wiper and Washer Switch Inspection
Reference: Windshield Wiper and Washer Switch Removal and Installation
Windshield Wiper and Washer Switch
Check for continuity between terminals at each switch position. If check result is not as specified, replace switch.
Intermittent Wiper Relay Circuit
1. Turn the windshield wiper switch to "INT" position.
2. Connect battery positive (+) terminal to terminal "5" and its negative (-) terminal to terminal "2".
3. Connect voltmeter positive lead to terminal "4" and its negative lead to terminal "2".
4. Check that the voltmeter indicates the battery voltage (10 - 14 V).
5. Connect terminal "3" and terminal "5" by a jumper wire.
6. Disconnect end of the jumper wire from terminal "5".
