Grand Vitara 2WD V6-3.2L (2010)
Power Steering Pump: Removal and Replacement
P/S Pump Removal and Installation
P/S Pump Removal and Installation
Removal
NOTE:
Be sure to clean each joint of suction and discharge sides thoroughly before removal.
1) Disconnect negative (-) cable at battery.
2) Take out P/S fluid in reservoir with syringe or such.
3) For J24B model, remove intake manifold.
4) Disconnect high pressure pipe and suction hose from P/S pump.
NOTE:
As fluid flows out of disconnected joints, put a receptacle under joints or a plug to pipe.
5) Disconnect pressure switch lead wire at switch terminal.
6) Remove accessory drive (P/S) belt.
7) Remove P/S pump mounting bolts (1).
8) Remove P/S pump (2).
NOTE:
Plug each port of removed pump to prevent dust or any other foreign matter from entering.
Installation
Reverse removal procedure, and then noting the following instructions.
NOTE:
^
Adjust accessory drive (P/S) belt.
^
Fill specified power steering fluid after installation and bleed air without failure.
Tightening torque
P/S pump mounting bolt: 25 Nm (2.5 kg-m, 18.5 lbf-ft)
