Grand Vitara 4WD L4-2.4L (2009)
Hydraulic Control Assembly - Antilock Brakes: Component Tests and General Diagnostics
CAUTION:
Make sure of the following conditions before ABS hydraulic unit operation check.
^
Otherwise, ABS hydraulic unit operation can not be checked properly.
^
No air is trapped in brake system.
^
Battery voltage is 11 V or more.
^
Brakes do not drag.
^
ABS control module has detected no DTC.
NOTE:
^
Operation check must be performed by 2 persons.
^
When installing new ABS hydraulic unit control module assembly, ABS warning light may flash at ignition switch is turned ON position.
Accordingly perform "Precautions in Hydraulic Unit Operation Check" to stop flashing of ABS warning light.
1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector (1) located on underside of instrument panel at driver's seat side.
Special Tool
(A): SUZUKI scan tool (SUZUKI-SDT)
3) Hoist vehicle until tire can be rotated.
4) Set transmission to neutral position and release parking brake.
