Grand Vitara 4WD L4-2.4L (2009)
Backup Lamp Switch: Service and Repair
Back Up Light Switch Removal and Installation
Removal
WARNING:
Refrain from work while exhaust No.2 pipe is hot.
NOTE:
When replacing switch, use care not to let dust enter transmission through switch hole.
1) Hoist vehicle and disconnect connector from back up light switch.
2) Remove back up light switch (1) from transmission rear case.
Installation
Reverse removal procedure for installation noting the following.
^
Apply oil to new O-ring (1) and then install back up light switch (2) to transmission rear case.
Tightening torque
Back up light switch (a): 23 Nm (2.3 kg-m, 17.0 lbf-ft)