Grand Vitara 4WD L4-2.4L (2009)
Turn Signal Relay: Testing and Inspection
Turn Signal And Hazard Warning Relay Inspection
1. Remove turn signal and hazard warning relay (1) from junction block (2).
2. Connect connector to turn signal and hazard warning relay.
3. Turn ignition switch to ON position.
4. Check turn signal and hazard warning relay for operation.
-
Check that left side turn signal lights flash when 5 terminals of turn signal and hazard warning relay and vehicle body ground are connected
using service wire (3).
-
Check that right side turn signal lights flash when 6 terminals of turn signal and hazard warning relay and vehicle body ground are connected
using service wire.
-
Check that left and right side turn signal lights flash when 8 terminals of turn signal and hazard warning relay and vehicle body ground are
connected using service wire. If turn signal lights do not flash, check power supply and ground circuits of turn signal and hazard warning relay.
