Grand Vitara 4WD L4-2.4L (2009)
Shift Linkage: Procedures
Gear Shift Control Lever Rear Case Assembly Removal and Installation
Removal
1) Dismount transmission assembly from vehicle referring to Manual Transmission Assembly Dismounting and Remounting.
2) Remove gear shift control lever rear case assembly (1) with plate (2) from transfer case or extension case.
Installation
1) Install gear shift control lever rear case assembly with its plate to transfer case or extension case referring to figure for proper installing direction
of control shaft joint bolt (2). Tighten plate bolts (1) and control shaft joint nut (3) to specified torque.
Tightening torque
Plate bolt (a): 23 Nm (2.3 kg-m, 17.0 lbf-ft)
Control shaft joint nut (b): 18 Nm (1.8 kg-m, 13.0 lbf-ft)