Grand Vitara JLS Plus 2WD V6-2.5L (2000)
Four Wheel Drive Selector Switch: Service and Repair
TRANSFER 4WD SWITCH
1. Remove console box and lift transmission control lever boots No. 2 and No. 3 (Refer to Shift Lever, M/T)
2. Remove transfer control lever boot No. 2, unclamp wiring on transfer case to free it and pull off coupler.
3. Replace switch and connect as it was .
Tightening Torque
(a): 20 Nm (2.0 kg.m, 14.5 ft. lbs.)
4. Turn ON ignition switch, shift transfer shift control lever to 4WD position and check that indicator lights. Turn OFF switch after checking
NOTE:
-
When removing and reinstalling switch, use care not to let dust enter transfer box inside.
-
Make sure to reset clamp for wiring which is located where invisible directly.
-
It is recommended to work on transfer shift control lever boot No. 1 from underside of vehicle on lift.
-
Identify this switch by its leg part which is different for that of back up light switch.