Grand Vitara JLS Plus 2WD V6-2.5L (2000)
16. Apply sealant to mating surface of bearing retainer with brake back plate.
NOTE: Make sure to remove old sealant before applying it anew.
"B": Sealant 99000-31110
17. Install rear axle shaft to rear axle housing and tighten bearing retainer nuts to specified torque.
NOTE: When installing rear axle shaft, be careful not to cause damage to oil seal lip in axle housing.
Tightening Torque (e): 23 Nm (2.3 kg-m, 17.0 ft. lbs.)
18. Tighten wheel speed sensor bolt to specified torque.
Tightening Torque (f): 21 Nm (2.1 kg-m, 15.5 ft. lbs.)
19. Connect brake pipes to wheel cylinders (right & left) and tighten brake pipe flare nuts to specified torque.
Tightening Torque (g): 16 Nm (1.6 kg-m, 11.5 ft. lbs.)
20. Install brake drum (right & left). For details, refer to Brakes and Traction Control.