Grand Vitara JLX 4WD V6-2.5L (1999)
Wheel Speed Sensor: Service and Repair
Rear Speed Sensor Ring/Rotor
REMOVAL
1. Remove rear axle shaft.
2. In order to remove sensor rotor from retainer ring, grind with a grinder one part of the sensor rotor as illustrated till it becomes thin.
CAUTION:
^
Cover vinyl sheet or the like over wheel bearing so that fine grains from grinding will not enter there.
^
Be careful not to go so far as to grind the retainer ring.
3. Break with a chisel the thin ground sensor rotor, and it can be removed.
INSTALLATION
1. Press-fit sensor rotor as shown.
NOTE: Use care not to cause any damage to outside of retainer ring.
2. Install rear axle shaft.
3. Install brake drum and wheel.