Grand Vitara LTD 2WD V6-2.5L (2001)
Brake Shoe: Testing and Inspection
BRAKE SHOE CHECK
Inspection should be carried out on following points after brake pedal travel "c" (pedal to asphalt sheet clearance) check, even when it is more than
115 mm (4.53 inch).
See: Brake Pedal Assy/Testing and Inspection
Amount of brake shoe wear can be checked as follows.
1. Hoist vehicle.
2. Remove rubber plug from brake back plate.
3. Through hole of back plate, visually check for thickness of brake shoe lining. If lining thickness "f" is found less than below specified wear limit,
replace with new brake shoes.
Rear brake shoe thickness "f":
Service Limit: 1.0 mm (0.04 inch)