Grand Vitara LTD 2WD V6-2.5L (2001)
11. Disconnect connectors of EVAP canister purge valve (1) and EGR valve (5).
12. Disconnect PCV hose (6), breather hose (3) and EVAP canister purge valve hose (2).
13. Remove EGR pipe (4).
14. Remove throttle body (3) and intake collector (2) from intake manifold (1).
15. Disconnect hoses of IAC valve and PCV from throttle body.
16. Remove throttle body from intake collector.
NOTE:
-
MAF sensor (4), TP sensor (5), or other components containing rubber must not be placed in a solvent or cleaner bath. A chemical reaction
will cause these parts to swell, harden or get distorted.
-
Don't put drills or wires into passages for cleaning. It causes damages in passages.
INSTALLATION
1. Clean mating surfaces and install throttle body gasket to intake collector (1) with new gasket (2).
2. Install throttle body to intake collector and tighten bolts.
3. Connect IAC valve hose and PCV hose.
4. Install throttle body and intake collector to intake manifold with new intake collector gaskets.
5. Install EGR pipe with new gaskets.
6. Connect PCV hose, breather hose and EVAP canister purge valve hose.
