Grand Vitara LTD 2WD V6-2.5L (2001)
2. Press-fit rear bushing until its flange contacts housing edge of control arm, use special tools.
Special tool
(E): 09925-58210
(F): 09913-85210
NOTE: When press-fitting bushing, compounding oil or soap water applied to inside of control arm housing will facilitate work.
3. Install control arm to chassis. Tighten suspension arm nut to specified torque after lowering hoist and vehicle in non-loaded condition.
Tightening torque
Front suspension arm nut (a): 85 Nm (8.5 kg-m, 61.5 ft. lbs.)
Front suspension arm nut (b): 127 Nm (12.7 kg-m, 92.0 ft. lbs.)
4. As installation procedure hereafter is the same as that for coil spring.
NOTE: For any tightening torque other than those specified in text, refer to torque specification table at the end of this section.