Kizashi AWD L4-2.4L (2010)
Keyless Start Control Module: Service and Repair
Keyless Start Control Module Removal And Installation
Keyless Start Control Module Removal and Installation
Removal
1. Disconnect negative (-) cable at battery.
2. Remove driver side instrument panel undercover.
3. Disconnect keyless start control module connectors (1) and harness clamp.
4. Remove nuts (2), and then remove keyless start control module (3).
Installation
Reverse removal procedure noting the following points.
-
If keyless start control module is replaced, perform "Immobilizer Key Registration" using SUZUKI scan tool. (refer to SUZUKI SDT Immobilizer
Control System Operator's Manual)