Kizashi AWD L4-2.4L (2010)
![background image](/suzuki/kizashi_awd/l4-2.4l/Page-1138021.png)
a) Check slide pins for rust, corrosion and other damage and replace them if defective.
b) Apply grease to inner side of new pin boot (1).
c) Direct pin boots (1) as shown and install them to rear brake caliper carrier (2).
NOTE:
Use rubber grease of which viscosity varies very little even at -40 degrees C (-40 degrees F).
d) Apply grease to slide pin (1).
NOTE:
Use rubber grease of which viscosity varies very little even at -40 degrees C (-40 degrees F).