Kizashi AWD L4-2.4L (2010)
3) Insert brake piston into caliper cylinder of front brake caliper.
4) Install bleeder plug to front brake caliper and tighten to specified torque.
Tightening torque
Bleeder plug: 8.0 Nm (0.82 kg-m, 6.0 lbf-ft)
Slide pin
1) Check the following points before installing slide pin to front brake caliper carrier.
a) Check slide pins for rust, corrosion and other damage and replace them if defective.
b) Apply grease to inner side of new pin boots (1).
c) Install pin boots (1) to front brake caliper carrier (2) as shown.
NOTE:
Use rubber grease of which viscosity varies very little even at -40 degrees C (-40 degrees F).
