Kizashi AWD L4-2.4L (2010)
Brake Master Cylinder: Testing and Inspection
Brake Fluid Level Inspection
Brake Fluid Level Inspection
WARNING:
Never use brake fluid other than specified.
Otherwise, brake hoses and rubber parts may get damaged or brake system may not operate normally.
CAUTION:
Do not allow brake fluid to get on painted surfaces. Painted surfaces will be damaged by brake fluid. If any fluid is spilled, flush it with water
immediately.
^
Be sure to use brake fluid indicated on brake master cylinder reservoir cap or in owner's manual.
^
Check that brake fluid level is between MAX and MIN marks on reservoir of brake master cylinder.
NOTE:
If brake warning light sometimes comes on during driving or brake fluid level on brake master cylinder reservoir is "MIN" or lower, check the
following points:
^
Thickness of front brake pads and rear brake pads
^
Fluid leakage from piston seal of brake caliper
^
Cracks or damage on brake hoses and brake pipes
^
Fluid leakage from brake master cylinder or reservoir
If any abnormality is found, repair or replace faulty parts.
After the repair, replenish brake fluid so that fluid level is between "MAX" and "MIN" marks on brake master cylinder reservoir.
