Kizashi AWD L4-2.4L (2010)
Clutch Switch: Service and Repair
CPP Switch (for Cruise Control) Removal and Installation
Removal
1. Confirm that ignition mode of keyless push start system is "OFF".
2. Remove instrument panel undercover (1).
3. Disconnect connector from CPP switch (for cruise control) (2).
4. Remove CPP switch (for cruise control) from pedal bracket.
Installation
1. Install CPP switch (for cruise control) (1) to pedal bracket.
2. With clutch pedal (4) released, adjust switch position so that clearance between end (3) of thread and clutch pedal bracket is within specification.
Clearance between end of thread and clutch pedal bracket
"a": 1.6 - 2.0 mm (0.063 - 0.079 in.)
3. Tighten lock nut (2) to specified torque.
Tightening torque
CPP switch lock nut (a): 7.5 N.m (0.8 kg-m, 5.5 lbf-ft)