Kizashi AWD L4-2.4L (2010)
Engine Block Heater: Service and Repair
Cylinder Block Heater Removal and Installation (If Equipped)
Cylinder Block Heater Removal and Installation (If Equipped)
Removal
1) Disconnect negative (-) cable at battery.
2) Drain coolant.
3) Remove exhaust manifold cover.
4) Remove block heater protector, and then disconnect block heater harness connector.
5) Remove cylinder block heater (1).
Installation
Reference: Cylinder Block Heater Inspection (If Equipped)
Reverse removal procedure for installation noting the following points:
^
Use new cylinder block heater bolts.
^
Tighten cylinder block heater bolts (1) to specified torque.
Tightening torque
Cylinder block heater bolt (a): 11 Nm (1.1 kg-m, 8.5 lbf-ft)