Kizashi AWD L4-2.4L (2010)
hold plunger in place.
14) Install timing chain tensioner adjuster (1) with a retainer.
Tighten timing chain tensioner adjuster bolts (2) to specified torque, and then remove a retainer from timing chain tensioner adjuster.
Tightening Torque
Timing chain tensioner adjuster bolt (a): 11 Nm (1.1 kg-m, 8.5 lbf-ft)
15) Apply engine oil to timing chain, turn crankshaft clockwise 720 degrees, and confirm that the following conditions have been met:
^
Timing mark (4) on CMP actuator is aligned with matchmark (3) on camshaft housing No.1.
^
Timing mark (5) on exhaust camshaft timing sprocket is aligned with matchmark (3) on camshaft housing No.1.
^
Timing mark (6) on crankshaft timing sprocket is aligned with matchmark (7) on lower crankcase.
NOTE:
^
Be sure to turn crankshaft 720 degrees. If it is turned only 360 degrees, the timing marks on CMP actuator and exhaust camshaft timing
sprockets will not meet matchmark on camshaft housing No.1.
^
After turning crankshaft 720 degrees, the painted links of the timing chain will not be aligned with the timing marks on the CMP actuator and
the exhaust timing sprocket, but this is normal.