Kizashi AWD L4-2.4L (2010)
Air Bag(s) Arming and Disarming: Service and Repair
Enabling Air Bag System
Enabling Air Bag System
1. Make sure that removed components are installed and/or disconnected connectors are connected properly.
2. Check that ignition mode is "OFF".
3. Connect negative (-) cable at battery and/or install "A/B" fuse to junction block.
4. Push engine switch to change ignition mode to "ON".
5. Check if "AIR BAG" warning light flashes for about 6 seconds and then comes off.
6. Perform Air Bag System Construction if defective.