Kizashi AWD L4-2.4L (2010)
Brake Lamp: Service and Repair
Rear Combination Light Removal and Installation
Removal
1. Remove trunk side trim.
2. Disconnect rear combination light connector.
3. Remove rear combination light nut (1).
4. Remove rear combination light (2) by pushing it in the direction of arrow.
5. Remove bulb.
Installation
CAUTION: Replace with new gasket if gasket (1) is deformed or torn, or water leakage may be caused.
Reverse removal procedure noting the following points.
-
Install rear combination light by pushing it in direction of arrow.