Kizashi AWD L4-2.4L (2010)
![background image](/suzuki/kizashi_awd/l4-2.4l/Page-801003.png)
b. Push engine switch to change ignition mode to "ON", clear DTC and select "ACTIVE TEST" mode on scan tool.
c. Turn ON fuel pump using scan tool.
When not using scan tool:
a. Remove fuel pump relay (1) from connector.
b. Connect two terminals of relay connector (2) using service wire (3) as shown in figure.
CAUTION: Be sure to connect to correct terminals. Connecting to an incorrect terminal could cause damage to ECM, wire harness,
etc.