Kizashi AWD L4-2.4L (2010)
10. Remove injector from special tool (A) and disconnect special tool (C) from injector.
WARNING: As fuel feed line is still under high fuel pressure even after inspection, removing injector directly may cause hazardous
spout of fuel. Before removing injector, make sure to relieve fuel pressure as follows.
1. Stop operation of fuel pump.
2. Put graduated cylinder under injector.
3. Apply battery voltage to injector until no fuel is injected from injector.
11. Carry out Steps 2) through 10) on each injector to obtain four readings.
12. After checking, remove special tools from fuel injector and fuel feed pipe.
13. Install fuel injector to cylinder head.
14. Connect fuel feed pipe to fuel delivery pipe.
15. Check for fuel leaks.