Kizashi AWD L4-2.4L (2010)
b. Disconnect ECM connectors.
c. Check each terminal of ECM connectors for proper connection.
d. Measure voltage between each terminal of ECM connector and ground in the following table.
If each measured voltage is out of specified voltage, repair or replace related part.
e. Confirm that ignition mode of keyless push start system is "OFF".
f.
Connect ECM connectors.
g. Measure voltage between each terminal of ECM connector and ground in the following table.
If each measured voltage is out of specified voltage, repair or replace related part.
2. Check throttle actuator power supply circuit as follows.
If each measured voltage is out of specified voltage, repair or replace related part.
3. Check ECM ground circuit as follows.
If each measured voltage is out of specified voltage, repair ECM ground circuits.