Kizashi AWD L4-2.4L (2010)
Knock Sensor: Service and Repair
Knock Sensor Removal And Installation
Removal
1. Disconnect negative (-) cable at battery.
2. Remove generator.
3. Disconnect knock sensor connector.
4. Remove knock sensor (1) from cylinder block.
Installation
Reverse removal procedure, noting the following points:
-
Install knock sensor (1) as shown in figure.
-
Tighten knock sensor bolt (2) to specified torque.
Tightening torque
Knock sensor bolt (a): 25 N.m (2.5 kg-m, 18.5 lbf-ft)