Kizashi AWD L4-2.4L (2010)
Air Bag: Removal and Replacement
Curtain Air Bag (Inflator) Module Removal and Installation
Curtain Air Bag (inflator) Module Removal And Installation
WARNING:
-
When handling an air bag (inflator) module, be sure to read Precautions for Handling and Storage of Air Bag System Components and
observe each instruction. Failure to follow them could cause damage to air bag (inflator) module or result in personal injury.
-
Do not install side curtain air bag (inflator) module while twisted or bent. Otherwise, side curtain air bag (inflator) module may not
deploy and injury may result.
NOTE: Refer to Repair and Inspection Required after Accident before replacing a deployed air bag.
Removal
1. Disable air bag system.
2. Remove front pillar trim, center pillar upper trim/lower trim and rear pillar inner trim.
3. Remove roof lining.
4. Disconnect curtain air bag (inflator) module connector (3) as show in figure.
a. Release lock (2).
b. Disconnect connector with lock released.
5. Remove curtain air bag (inflator) module bolt and remove curtain air bag (inflator) module.
Installation