Kizashi AWD L4-2.4L (2010)
-
Enable air bag system.
Rear Side Air Bag (Inflator) Module Removal and Installation
Rear Side Air Bag (Inflator) Module Removal And Installation
WARNING: When handling an air bag (inflator) module, be sure to read Precautions for Handling and Storage of Air Bag System
Components and observe each instruction. Failure to follow them could cause damage to air bag (inflator) module or result in personal injury.
NOTE: Refer to Repair and Inspection Required after Accident before replacing a deployed air bag.
Removal
1. Disable air bag system.
2. Remove rear seat cushion assembly.
3. Remove rear bolster.
4. Remove rear pillar inner trim.
5. Open cap (1).
6. Disconnect rear side air bag (inflator) module connector (3) as show in figure.
a
Release lock (2).
b
Disconnect connector with lock released.
