Kizashi AWD L4-2.4L (2010)
Seat Belt Tensioner: Procedures
Deployed Air Bag (Inflator) Module and Activated Seat Belt Pretensioner Disposal
Deployed Air Bag (inflator) Module And Activated Seat Belt Pretensioner Disposal
WARNING: Failure to follow proper air bag (inflator) module and seat belt pretensioner disposal procedures can result in air bag deployment
and pretensioner activation which may cause personal injury. Undeployed air bag (inflator) module and inactivated seat belt pretensioner must
not be disposed of through normal refuse channels. Undeployed air bag (inflator) module and inactivated seat belt pretensioner contains
substances that can cause severe illness or personal injury if sealed container is damaged during disposal.
Deployed air bag (inflator) module and activated seat belt pretensioner can be disposed of in the same way which is used for disposal of any other parts.
For their disposal, however, the following points should be noted.
-
Immediately after deployment / activation air bag (inflator) module and seat belt pretensioner are hot. Wait for 30 minutes to cool it off before
handling it.
-
Never apply water and oil etc. to deployed air bag (inflator) module and activated seat belt pretensioner to cool them off. Do not get on deployed
air bag (inflator) module and activated seat belt pretensioner.
-
After air bag (inflator) module has been deployed, surface of air bag may contain a powdery residue. As with many service procedures, you should
wear gloves and safety glasses.
-
When disposing of deployed air bag (inflator) module and activated seat belt pretensioner, be sure to seal it in a vinyl bag.
