Kizashi AWD L4-2.4L (2010)
Brake Fluid Pressure Sensor/Switch: Testing and Inspection
Brake Master Cylinder Pressure Sensor On-Vehicle Inspection
1) Calibrate sensors.
2) Check basic brake system other than ESP(R).
3) Confirm that ignition mode of keyless push start system is in "OFF".
4) Connect SUZUKI scan tool to DLC (1).
Special Tool
(A): SUZUKI scan tool (SUZUKI-SDT)
5) Push engine switch to change ignition mode of keyless push start system to "ON" and select menu "DATA LIST" mode of SUZUKI scan tool.
Refer to scan tool operator's manual for further details.
6) Check "Master Cyl Press" under "DATA LIST" of SUZUKI scan tool with brake pedal released. If check result is not as specified, replace ESP(R)
hydraulic unit / control module assembly.
Master cylinder pressure specification
Brake pedal released: 0 ± 0.8 MPa (0 ± 8.2 kgf/cm2, 0 ± 116 psi)
7) Hoist vehicle and remove left-side front wheel.
8) Remove bleeder plug from left-side front caliper and install special tool to left-side front caliper.
Special Tool
(A): 09956-02311
